67-70 Mustang Power Brake Conversion Disc, Manual
67 - 70 Mustang Power Brake Conversion (Disc, Manual Trans)
1967 1968 1969 1970 Ford Mustang Power Brake Conversion (Disc Brakes on Front, Manual Transmission). This Kit Will Use Your Stock Non-power Pedal So You Do Not Have To Buy A New Power Pedal For Your Mustang.
Sold as EACH
Now available from Scott Drake. The safety and increased stopping power you have been looking for on any 1964-70 Mustang in a very easy to install unit. This setup utilizes a new American made Bendix power brake booster with increased sensitivity and new large capacity dual chamber master cylinder, specially designed mounting bracket to allow direct bolt in while retaining original brake pedal assembly and clearance of the shock tower. The push rod is preset but is adjustable to move the pedal height up or down. The only modification necessary is bending new lines from the master cylinder to the distribution block. See below for brake lines to simplify the installation. We also offer a rebuilt distribution block part number C7ZZ-2B257-A which is not included in the Power Brake Conversion. This part may be required depending on what your car is currently equipped with. 1967-1970 cars already have one from the factory but it is a good idea to replace it. This kit is easy to install. This is a very economical solution for Those looking for an improved braking system along with the added safety of a dual chamber master cylinder.
PLEASE NOTE: Booster requires a minimum 15 pounds of engine vacuum pressure at idle for maximum stopping power. Some high performance high lift camshafts may not create enough vacuum. Stock engine vacuum pressure is 18 pounds. 1 year warranty on Master Cylinder and Booster.
- Item Requires Shipping
- 17.3 lbs.
- W12.5000” x H10.5000” x L20.0000”
- FREE SHIPPING on orders *$99 or more
Total Reviews (0)
Write the First Review!
You must login to post a review.